Damper for lifting units to Mercedes-Benz
Description:
The damper element made of co-polyester elastomer is used in the jacking units in progressive dies in the automotive and white goods industry. Increasing stresses on screws and bolts are reduced by the low stress dampers. Reduced noise emission is also an additional positive side-effect. Two-ply dampers can be used depending on the mass or stroke.
Benefits:
- High absorption of force and energy
- Slight settlement
- Long service life and high level of operating safety
- Noise reduction
- High degree of effectiveness Material:
Co-Polyester-Elastomer
Available in 55 Shore-D hardness levels.
Technical data:
Surroundings: Resistant to microbes, seawater, chemicals.
No absorption of water and no swelling.
Approved temperature range: -40°C to +90°C (-40°F to +194°F)
The damper element made of co-polyester elastomer is used in the jacking units in progressive dies in the automotive and white goods industry. Increasing stresses on screws and bolts are reduced by the low stress dampers. Reduced noise emission is also an additional positive side-effect. Two-ply dampers can be used depending on the mass or stroke.
Benefits:
- High absorption of force and energy
- Slight settlement
- Long service life and high level of operating safety
- Noise reduction
- High degree of effectiveness Material:
Co-Polyester-Elastomer
Available in 55 Shore-D hardness levels.
Technical data:
Surroundings: Resistant to microbes, seawater, chemicals.
No absorption of water and no swelling.
Approved temperature range: -40°C to +90°C (-40°F to +194°F)
Log in to view price, availability, and order the product.
Order No
2478.20.20.3
Outside diameter
39.5 mm
Inner diameter
32.2 mm
D3
39.6 mm
Length
12.6 mm
F
3.6 mm
Power consumption
4 Nm/Hub
Customer tariff number
82073010